User Tools

Site Tools



This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
setup:lite [2017/04/29 09:42]
setup:lite [2017/04/29 09:49]
Line 17: Line 17:
 {{ :​setup:​screenshot_21.png?​nolink&​600 |}} {{ :​setup:​screenshot_21.png?​nolink&​600 |}}
 +Unzip the zip file and open the '​lite'​ folder, open the lite.ino file, this should open in the Arduino IDE.
 +Next in the menu bar select Tools > Board > Arduino/​Genuino Micro
 +Then select Tools > Port > (Arduino/​Genuino Micro)
 +Finally go to Sketch > Upload
 +Once the sketch has uploaded you can remove the lite and toggle it's switch, putting it into the '​on'​ position, then just stick it in a computer and it'll run. To put the lite back into programming mode simply toggle the switch into the '​off'​ position and put it back into your computer for programming.
setup/lite.txt ยท Last modified: 2017/04/29 09:49 by seytonic